2(HELIX'3!ISSUITABLEFORTHE
machining of aluminum, aluminum-alloys and other soft
materials up to 700 N/mm.
Advantages at a glance:
sREDUCEDPOWERREQUIREMENTANDCUTTINGPRESSURE
sSUITABLEFORLESSPOWERFULANDLESSSTABLEMACHINES
sSUITABLEFORLESSFAVORABLEWORKPIECEANDTOOLCLAMPING
conditions
sHIGHMETALREMOVALRATETHANKSTOTHEUTILIZATIONOFTHE
complete cutting edge length
In comparison with conventional tools, GS 100 A roughing
cutters with internal cooling excel with considerably
longer tool life and higher feed rates as well as increased
feed engagement widths and depths. Guhring milling
cutters with radial coolant exits at 64° provide particular
protection to the sensitive corners. The specifically aimed
coolant exits completely prevent built-up edges and ensure
complete chip evacuation, especially with deep pockets
and channels.
Hardness up to 28HRc up to 28 HRc up to 3% Si Ti-based up to 52 HRC over 52 HRC
tensile over 28 HRc over 28 HRc over 3% Si Ni-based
strength
ss
sRough-Tech ALU s = limited suitability
s = optimal suitability
92 guhring@guhring-tools.ru
www.guhring-tools.ru
