для размещения заказа - guhring@guhring-tools.ru
HPC milling cutters
Adjustment instructions
Adjustment instructions
HPC milling cutters
The chip-guiding elements are assembled at the factory! 1
1. Determine the highest chip guiding element.
CGE-set
Recommendation:
Place milling cutter in a setting xture and rotate under CS1
the dial test indicator (DTI) and measure the individual CS2
chip guiding elements. (pict. 1) AS
2. Install the inserts and tighten the clamping
screw (CS 1) to 15 Ncm.
Do not tighten the clamping screw (CS 2) !
3. Adjust the inserts in the axial direction with the
adjustment screw (AS) to 10 m below the nal
setting dimension.
Setting dimension = highest chip guiding element SW
height +30 m
The face run-out should be max. 2 m.
4. Firmly tighten the clamping screw (CS 2) to 80 Ncm to perfectly align the insert then
loosen again and re- tighten to 15 Ncm.
5. Tighten the clamping screw (CS 1) to 80 Ncm.
6. Adjust all inserts to the setting dimension. The face run-out should be max. 2 m.
Tighten the clamping screw (CS 2) to 80 Ncm.
7. A control measurement has to be carried out after 10 minutes. If the face run-out is more than
2 m, readjust the cutting plates without retightening the clamp screws.
Safety note:
In the event of damage the tool must be returned to the manufacturer for checking for technical
safety reasons! Only original replacement parts must be used!
Recommended torque wrench: 11
E 6000 adjustable 10-80 Ncm Tx 6
Tx-bits 6 Bit Tx 6 for adjustable torque wrench E6000
Tx-bits 8 Bit Tx 8 for chip guiding elements (80 Ncm)
E 6001 xed 15 Ncm Tx 6
E 6002 xed 80 Ncm Tx 6
guhring@guhring-tools.ru
www.guhring-tools.ru
