для размещения заказа - guhring@guhring-tools.ru
Adjustment system
Tapered screw adjustment m-accurate adjustable
Adjustment instruction
Adjustment element (tapered screw/torx)
Clamping set
1. Changing the insert
Disassembly
Loosen clamping set (1 to 2 turns) and remove the worn insert
Clean the insert pocket
Turn out the adjustment element 1 to 2 turns
Assembly
Put a new insert in the pocket seat
Press insert into the pocket seat, keep under pressure and slightly tighten the clamp set:
Torx 5 with 40 Ncm Torx 6 with 60 Ncm
Torx 8 with 100 - 120 Ncm Torx 15 with 250 - 300 Ncm
2. Insert adjustment
Clamp the holder in the presetting device
Adjust the insert in diameter up to 0.05 mm smaller than target measure
Tighten the clamp set
We recommend to use our torque wrench:
E 5000 adjustable 20 - 120 Ncm E 5400-5 xed 45 Ncm for Tx5 E 5400-8 xed 140 Ncm for Tx8
E 5400-15 xed 345 Ncm for Tx15
E 5001 adjustable 100 - 600 Ncm E 5400-6 xed 70 Ncm for Tx6
Adjust insert to the required machining diameter (It is not necessary to retighten the clamping set!)
Torque for clamping elements
Tool body Clamping set Torque Torx size
Series (Ncm)
E 1100 Tx 5
H 1035 E 3441 45 Tx 5
H 1730 E 1085 / E 1112 45 Tx 6
H 2850 E 1060 70 Tx 8
H 3570 E 1040 140 Tx 15
H 4090 345
57
guhring@guhring-tools.ru
www.guhring-tools.ru
