HOLLFELDER - Основной каталог - 2013 EN

                                                 для размещения заказа - guhring@guhring-tools.ru

        Adjustment system

        Radial adjustment m-accurate adjustable

Adjustment instruction                                                                                   SW 0,7  SW 1,3
                                                                                                         SW 0,9  SW 1,5
   Adjustment element
   (radial pushing screw)                                                                                                  Clamping screw

Insert                                                                                                                      Pushing pin

                                                                                                                 Clamping set

1. Changing the insert

Disassembly
    Loosen clamping set (1 to 2 turns) and remove the worn insert

Clean the insert pocket

Turn out the adjustment element 1 to 2 turns

Assembly
    Put a new insert in the pocket seat

Press insert into the pocket seat, keep under pressure and slightly tighten the clamp set:

Torx 5 with 40 Ncm            Torx 6 with 60 Ncm

Torx 8 with 100 - 120 Ncm Torx 15 with 250 - 300 Ncm

2. Insert adjustment
      Clamp the holder in the presetting device

Adjust the insert in diameter up to 0.05 mm smaller than target measure

Tighten the clamp set                                                                                    E 5400-8 xed 140 Ncm for Tx8
We recommend to use our torque wrench:                                                                   E 5400-15 xed 345 Ncm for Tx15
E 5000 adjustable 20 - 120 Ncm E 5400-5 xed 45 Ncm for Tx5
E 5001 adjustable 100 - 600 Ncm E 5400-6 xed 70 Ncm for Tx6

Adjust insert to the required machining diameter (It is not necessary to retighten the clamping set!)

Torque for clamping elements

        Tool body              Clamping set           Torque                                                     Torx size
          Series                                      (Ncm)
                                    E 1100                                                                          Tx 5
          H 1035                    E 3441               45                                                         Tx 5
          H 1730              E 1085 / E 1112            45                                                         Tx 6
          H 2850                    E 1060               70                                                         Tx 8
          H 3570                    E 1040             140                                                          Tx 15
          H 4090                                       345

66

                                                                               guhring@guhring-tools.ru
                                                                                  www.guhring-tools.ru