GUHRING - Концевые фрезы - 2013 EN

                                                                для размещения заказа - guhring@guhring-tools.ru

ROUGH-TECH 56 GS 100 H roughing cutters
for materials < 54 HRC

                                                                                    GS 100 roughing cutters excel
                                                                                    primarily thanks to their general
                                                                                    purpose application possibilities
                                                                                    enabling almost any combination of
                                                                                    cutting depth (DOC) and cutting width
                                                                                    (WOC). In comparison to roughing/
                                                                                    finishing cutters with a flat knuckle-
                                                                                    type geometry, the considerably
                                                                                    lower power requirement ensures a
                                                                                    reliable and economical machining
                                                                                    process especially with less powerful
                                                                                    machines.

     GS 100 H: special geometry for
     materials < 54 HRC:
     s'3(EXCELSINTHEMACHINING

      of difficult-to-machine materials over
      1000 N/mm, cast iron and grey cast
      iron as well as hardened materials
      up to approximately 52 to 54 HRC
      thanks to its 20° helix and its small
      rake angle.

     Advantages at a glance:
     sREDUCEDPOWERREQUIREMENTAND

      cutting pressure
     sSUITABLEFORLESSPOWERFULANDLESS

      stable machines
     sSUITABLEFORLESSFAVORABLEWORKPIECE

      and tool clamping conditions
     sHIGHMETALREMOVALRATETHANKSTO

      the utilisation of the complete cutting
      edge length

     Material                  Alloyed              up to 180 HB 30       Stainless          Aluminium         Ti-special      H
                                  Steel                Cast iron             steel                                alloys
                                        Tool Steel
                                                          over 180 HB 30
     Hardness                  up to 28HRc                                up to 28 HRc       up to 3% Si       Ti-based        up to 52 HRC  over 52 HRC
       tensile                        over 28 HRc                               over 28 HRc        over 3% Si        Ni-based
      strength

     Rough-Tech 48 s s s s s s s s s s
     s s s sRough-Tech 56                                                                                      ssss
     s = optimal suitability                        s = limited suitability

100  guhring@guhring-tools.ru
       www.guhring-tools.ru