GUHRING - Концевые фрезы - 2013 EN

                                                                для размещения заказа - guhring@guhring-tools.ru

AERO-TECH / GH 100 U
high-performance end mills

The new design Guhring GH 100 U end mills offer the ultimate pre-requisite for a cost-efficient, optimal machining of general
steels, high-alloyed steels, CrNi steels as well as stainless steels and titanium-alloys up to 50 HRC.

All GH 100 U end mills excel thanks to their micro-corner protection combined with a reinforced and corrected minor cutting
edge. This design considerably reduces the wear at the cutting edges allowing a higher feed rate as well as improved tool
life.

Micro-corner protection and corrected reinforced                                                             GH 100 U end mills (3-fluted) excel
cutting edge = optimal stability                                                                             further thanks to their optimized flute
                                                                                                             geometry, achieving ultimate machining
                                                                                                             efficiency especially for slot milling and
                                                                                                             roughing operations. Paired with a very
                                                                                                             high spiral, optimal chip evacua-
                                                                                                             tion is achieved while reducing vibration.
                                                                                                             The advantages:

                                                                                                             UHGXFHGZHDU
                                                                                                             KLJKIHHGUDWHVSRVVLEOH
                                                                                                             RSWLPDOFKLSHYDFXDWLRQ
                                                                                                             FDQEHDSSOLHGIRUURXJKLQJ

                                                                                                              and finishing

Material                                                                                                     Alloyed              up to 180 HB 30       Stainless          Aluminium         Ti-special      H
                                                                                                                Steel               Cast iron              steel                                alloys
                                                                                                                      Tool Steel
                                                                                                                                        over 180 HB 30
Hardness                                                                                                     up to 28HRc                                up to 28 HRc       up to 3% Si       Ti-based        up to 52 HRC
  tensile                                                                                                           over 28 HRc                               over 28 HRc        over 3% Si        Ni-based        over 52 HRC
 strength

 Aero-Tech                                                                                                  s ssssssssss
Alumi-Tech                                                                                                   s                                                             ss

sRough-Tech ALU                                                                                                                                                            ss
Aero-Rough 48 s s s s s s s s s s
s s s s s sAero-Rough 56                                                                                                                                                                     ssss
Rough-Tech 48 s s s s s s s s s s
s s s sRough-Tech 56                                                                                                                                                                         ssss
Finish-Tech 50 s s s s s s s s s s s
Finish-Tech 62                                                                                                                    ss                                                         sss

GF 500 s s s s s s s s s
GF 300                                                                                                          s ss                                                                         ssss

Uni-Pro (all) s s s s s s s s s s
s = optimal suitability                                                                                                           s = limited suitability

84 guhring@guhring-tools.ru

                                                                                       www.guhring-tools.ru